FAQ for Differential Repair
Q: What is the procedure for rear drive axle lubricant Level Inspection?
A:
The procedure is to raise the vehicle, make sure the vehicle is level, inspect the rear axle for leaks and the lubricant level, install the rear axle fill plug and gasket, and then lower the vehicle.
By BobGM Specialist
01/11/2022 Q: What is the procedure for rear drive axle lubricant Level Inspection (9.5, 10.5 Inch Axle)?
A:
The procedure is to raise the vehicle, make sure the vehicle is level, inspect the rear axle for leaks and the lubricant level, install the rear axle fill plug, and then lower the vehicle.
By BobGM Specialist
01/11/2022 Q: What is the proper way to install the front drive axle lubricant?
A:
The proper way is to install the drain plug, the fill plug, and the front differential carrier shield, and then lower the vehicle.
By BobGM Specialist
01/11/2022 Q: What is the procedure for lubricant Level Inspection?
A:
The procedure is to raise the vehicle, make sure the vehicle is level, inspect the rear axle for leaks and the lubricant level, install the rear axle fill plug and gasket, and then lower the vehicle.
By BobGM Specialist
01/11/2022 Q: What is the procedure for rear drive axle lubricant Level Inspection (9.75 Inch Axle)?
A:
The procedure is to raise the vehicle, ensure the vehicle is level, inspect the rear axle for leaks and the lubricant level, install the rear axle fill plug, and then lower the vehicle.
By BobGM Specialist
01/11/2022 Q: What is the proper way to install the rear axle housing cover and gasket?
A:
The proper way is to install the rear axle housing cover and a new gasket, the new rear axle housing cover bolts, fill the rear axle and then lower the vehicle.
By BobGM Specialist
01/11/2022 Q: What is the proper way to install the rear drive axle lubricant?
A:
The proper way is to install the rear axle drain plug, fill the rear axle, and then lower the vehicle.
By BobGM Specialist
01/11/2022 Q: What is the cause of the noise?
A:
The cause is that this noise may be caused by a low clearance condition within the differential in the front axle assembly. In the 2WD mode, the front differential has a large amount of relative motion between the differential pinion and side gears.
By BobGM Specialist
01/11/2022 Q: What is the proper way to install the rear axle housing?
A:
The proper way is to install the pinion bearing cups, the drive pinion oil seal, the drive pinion, the pinion yoke, the differential assembly, the brake backing plates, and the rear axle assembly.
By BobGM Specialist
01/11/2022 Q: What is the removal procedure for the rear axle housing?
A:
The procedure is to remove the rear axle assembly, the brake caliper brackets, the axle shafts, the brake backing plates, the differential assembly, and the pinion-bearing cups.
By BobGM Specialist
01/11/2022 See more FAQs (9)