Part Description: 2004 Chevrolet Silverado 1500 Cable, Battery Negative
More Info
Vehicle Fitment
2004 Chevrolet Silverado 1500 | Base, Hybrid, LS, LT, LTZ, SS, WT, Z71 | 8 Cyl 4.8 L GAS, 8 Cyl 5.3 L ELECTRIC/GAS, 8 Cyl 5.3 L FLEX, 8 Cyl 5.3 L GAS, 8 Cyl 6.0 L GAS
FAQ for Battery Cables Repair
Q: What is the proper way to install the battery negative cable?
A:
The proper way is to install the negative battery cable, tighten the negative battery cable bolt, and then reset the customer's radio stations.
By Bob
GM Specialist
01/11/2022
Q: What is the removal procedure for the battery negative cable?
A:
The procedure is to record the customer's pre-set radio stations, turn off all the lamps and accessories, turn the ignition OFF, loosen the negative battery cable bolt, and then remove the negative battery cable.
By Bob
GM Specialist
01/11/2022
Q: What is the proper way to install the battery positive cable?
A:
The proper way is to install the auxiliary battery positive cable, clip the mega fuse to the auxiliary battery tray, and then install the auxiliary battery.
By Bob
GM Specialist
01/11/2022
Q: What should be noticed about battery disconnect?
A:
Unless directed otherwise, the ignition and start switch must be in the OFF or LOCK position, and all electrical loads must be OFF before servicing any electrical component. Disconnect the negative battery cable to prevent an electrical spark should a tool or equipment come in contact with an exposed electrical terminal. Failure to follow these precautions may result in personal injury and/or damage to the vehicle or its components.
By Bob
GM Specialist
01/11/2022
Q: What is the removal procedure for the battery-positive cable?
A:
The procedure is to remove the auxiliary battery, unclip the mega fuse, and then remove the auxiliary positive cable and the auxiliary battery positive cable.
By Bob
GM Specialist
01/11/2022
FAQ for Other Repair Info
Q: What is the removal procedure for the starter shield?
A:
The procedure is to remove the Starter motor, the starter heat shield bolts, and the starter heat shield.
Q: What should be done before reprogramming?
A:
You should check the battery condition to prevent a reprogramming error of any of the modules due to battery discharge.
Q: What is the proper way to install the generator cable?
A:
The proper way is to install the generator cable, the generator cable nut, and the engine sight shield, and then connect the negative battery cable.