FAQ for Horn Relays Repair
Q: What is the next step after performing the Horns Diagnostic System Check?
A:
You should depress the horn switch.
By BobGM Specialist
01/11/2022 Q: What should you do when testing the relay control circuit?
A:
You should test the horn slip ring and horn switch for a short to ground when testing the relay control circuit.
By BobGM Specialist
01/11/2022 Q: What should you do if the connector has a nose piece?
A:
You should use a small flat-bladed tool to remove the nose piece by inserting the blade into the slot on the front of the connector and prying it up on the nose piece.
By BobGM Specialist
01/11/2022 Q: What tool can you use to unlock the dress cover?
A:
You can use a small flat-bladed tool.
By BobGM Specialist
01/11/2022 Q: What is the purpose of sliding the horn assembly rearward?
A:
The purpose is to locate the stud in the large portion of the keyhole slot.
By BobGM Specialist
01/11/2022 Q: What is the recommended torque when tightening the bolt?
A:
You can tighten the bolt to 9 N.m (80 lb in).
By BobGM Specialist
01/11/2022 Q: What may be the cause of intermittent conditions?
A:
Faulty electrical connections or wiring may be the cause of intermittent conditions.
By BobGM Specialist
01/11/2022 Q: When should you perform the DIM programming procedure?
A:
You should perform the DIM programming procedure when replacing the DIM.
By BobGM Specialist
01/11/2022 Q: What is the purpose of reviewing the system operation?
A:
The purpose is to familiarize yourself with the system's functions.
By BobGM Specialist
01/11/2022 See more FAQs (4)