Part Description: 2004 Cadillac SRX Switch, Driver Seat Adjuster Memory
More Info
Vehicle Fitment
2004 Cadillac SRX | Base | 6 Cyl 3.6 L GAS, 8 Cyl 4.6 L GAS
FAQ for Door Lock Switch Repair
Q: How do you replace the power door lock switch?
A:
You can remove the inside handle bezel from the inner door panel and disconnect the electrical connector from the lock switch.
By Bob
GM Specialist
01/11/2022
Q: What is the removal procedure for the door control module?
A:
The procedure is to remove the door trim panel, remove the door control module and disconnect the electrical connectors.
By Bob
GM Specialist
01/11/2022
Q: What is the removal procedure for the front door switch?
A:
The procedure is to insert a flat-bladed tool under the front edge of the front door switch, push the tool firmly towards the switch, lift it on the rear of the switch plate, disconnect electrical connectors and remove the appropriate switch from the bezel.
By Bob
GM Specialist
01/11/2022
Q: How do you install the door control module?
A:
You can connect the electrical connectors, snap the door module, install the door trim panel and reprogram the front door module.
By Bob
GM Specialist
01/11/2022
Q: What is the proper way to install the door control module?
A:
You can connect the electrical connectors to the control module, snap the door module onto the mounting studs, install the door trim panel and reprogram the front door module.
By Bob
GM Specialist
01/11/2022
Q: What is the proper way to install the power door lock switch?
A:
You can snap the door lock switch into the door switch bezel, connect the electrical connector, slide the bezel over the door handle and snap the bezel into position.
By Bob
GM Specialist
01/11/2022
Q: What must you reprogram when replacing door control modules on export vehicles?
A:
You must reprogram the door module to relearn the vehicle identification number (VIN).
By Bob
GM Specialist
01/11/2022
Q: How do you install the front door switch?
A:
You can snap the switch into the bezel, connect the electrical connectors, install the switch into the door trim panel, engage the rear of the switch to the door panel and press down on the switch plate evenly to engage the retainer.
By Bob
GM Specialist
01/11/2022
Q: How do you replace the door control module?
A:
You can remove the door trim panel, remove the door control module and disconnect the electrical connectors from the control module.
By Bob
GM Specialist
01/11/2022
See more FAQs (4)
FAQ for Other Repair Info
Q: How do you replace the front door check link?
A:
You can remove the following: the door trim panel, the Door Check link to the body bolt, the check link to the door nuts, and the check link from the door.
Q: What is the recommended torque when installing the bolts?
A:
You can tighten the hinge to pillar bolts to 25 N.m (18 lb-ft).
Q: What tool can you use to lift the electrical connector lock and disconnect the electrical connector?