FAQ for Alternator Repair
Q: How to perform when removing the generator cable from the generator?
A:
You need to slide the boot down revealing the terminal stud and remove the generator cable nut from the terminal stud and the generator cable.
By BobGM Specialist
28/10/2022 Q: What is the recommended bolt torque for the generator bracket bolts?
A:
The recommended bolt torque is 50 Nm (37 lb-ft).
By BobGM Specialist
28/10/2022 Q: What is the recommended bolt torque for the generator bolts?
A:
The recommended bolt torque is 50 Nm (37 lb-ft).
By BobGM Specialist
28/10/2022 Q: What is the removal procedure for the generator bracket?
A:
You need to remove the battery cable junction block bracket bolts, the generator, the power steering pump, the generator bracket bolts, and the generator bracket.
By BobGM Specialist
28/10/2022 Q: Which is an incorrect Amp code stamped on the generator?
A:
The code on the side of the generator reads 130 A and it should read 145 A. The 130 A has been stamped on the generators in error and does not indicate the actual amperage of the generator.
By BobGM Specialist
28/10/2022 Q: What is the removal procedure for the generator?
A:
You need to disconnect the negative battery cable, remove the accessory drive belt and the engine sight shield, disconnect the generator electrical connector, and remove the generator cable from the generator, the generator bolts, and the generator.
By BobGM Specialist
28/10/2022 Q: What is the removal procedure for the generator cable?
A:
You need to disconnect the negative battery cable, remove the engine sight shield and the generator cable from the generator, open the positive cable junction block, remove the generator cable nut and remove the generator cable from the junction block.
By BobGM Specialist
28/10/2022 Q: What is the recommended bolt torque for the generator cable nut?
A:
The recommended bolt torque is 9 Nm (80 lb in).
By BobGM Specialist
28/10/2022 Q: What do the all grounds, in-line connectors, pass-through grommets, and splices have?
A:
All grounds, in-line connectors, pass-through grommets, and splices have identifying numbers that correspond to where they are located in the vehicle.
By BobGM Specialist
28/10/2022 See more FAQs (4)