Part Description: 2004 Cadillac CTS Rear Side Door Lock Assembly
More Info
Vehicle Fitment
2004 Cadillac CTS | Base, Luxury, Luxury Sport, V | 6 Cyl 2.8 L GAS, 6 Cyl 3.2 L GAS, 6 Cyl 3.6 L GAS, 8 Cyl 5.7 L GAS, 8 Cyl 6.0 L GAS
FAQ for Door Latch Assembly Repair
Q: What is the removal procedure for the rear side door latch?
A:
The procedure is to remove the door trim panel, the door module, the inside door handle, the water deflector, the door latch, and the handle rod.
By Bob
GM Specialist
01/11/2022
Q: What is the proper way to install the front side door latch?
A:
The proper way is to install the inside door handle rod, the electrical connector, the door latch, the lock cylinder rod, the lock knob rod, the water deflector, and the door trim panel.
By Bob
GM Specialist
01/11/2022
Q: What should be done for correction?
A:
You should verify that the striker properly engages the latch and that no obstructions are preventing the door from closing, allow the latch to completely thaw out, and spray GM Super Lube(R) on BOTH sides of the latch detent lever for approximately two to three seconds, and then repeat this procedure on all doors.
By Bob
GM Specialist
01/11/2022
Q: What is the proper way to install the rear side door latch?
A:
The proper way is to install the inside door handle rod, the door latch, the door latch screws, the inside handle rod, the water deflector, the door module, and the door trim panel.
By Bob
GM Specialist
01/11/2022
Q: What is the removal procedure for the front side door latch?
A:
The procedure is to remove the door trim panel, the water deflector, the lock knob rod, the inside handle rod, the door latch, the handle rod, and the lock rod.
By Bob
GM Specialist
01/11/2022
FAQ for Other Repair Info
Q: What is the removal procedure for the front side door check link?
A:
The procedure is to remove the door trim panel, the Door Check link, and the check link.
Q: How to install the power door lock switch?
A:
You should snap the Door Lock Switch into the door switch bezel, connect the electrical connector, slide the bezel over the door handle, and then snap the bezel into position by pushing on the lower front corner of the bezel.
Q: What is the removal procedure for the front side door hinge?
A:
The procedure is to remove the push-in fasteners, the fender sound insulator, and the hinge bolts.