FAQ for Door Lock Switch Repair
Q: How to install the power door lock switch?
A:
You should snap the door lock switch into the door switch bezel, connect the electrical connector, slide the bezel over the door handle, and then snap the bezel into position by pushing on the lower front corner of the bezel.
By BobGM Specialist
01/11/2022 Q: What is the removal procedure for the door control module?
A:
The procedure is to remove the door trim panel, remove the door control module by releasing the retainer tabs, and then disconnect the electrical connectors from the control module.
By BobGM Specialist
01/11/2022 Q: How to remove the power door lock switch?
A:
You should remove the inside handle bezel from the inner door panel, and then disconnect the electrical connector from the lock switch.
By BobGM Specialist
01/11/2022 Q: What should be done to install the front door switch?
A:
You should snap the switch into the bezel, connect the electrical connectors, install the switch into the door trim panel, engage the rear of the switch to the door panel, and then press down on the switch plate evenly to engage the retainer.
By BobGM Specialist
01/11/2022 Q: How to install the door lock switch?
A:
You should snap the door lock switch into the door switch bezel, connect the electrical connector, slide the bezel over the door handle, and then snap the bezel into position by pushing on the lower front corner of the bezel.
By BobGM Specialist
01/11/2022 Q: What is the proper way to install the door control module?
A:
The proper way is to connect the electrical connectors to the control module, snap the door module onto the mounting studs, install the door trim panel, and then reprogram the front door module.
By BobGM Specialist
01/11/2022 Q: How to remove the door lock switch?
A:
You should remove the inside handle bezel from the inner door panel, and then disconnect the electrical connector from the lock switch.
By BobGM Specialist
01/11/2022 Q: What should be done to remove the front door switch?
A:
You should insert a flat-bladed tool under the front edge of the front door switch, push the tool firmly towards the switch to disengage the retainer, lift on the rear of the switch plate to remove it from the door trim panel, disconnect electrical connectors, and then remove the appropriate switch from the bezel by disengaging the side snap walls with a small flat-bladed tool.
By BobGM Specialist
01/11/2022 See more FAQs (3)