FAQ for Hvac Heater Blend Door Actuator Repair
Q: What is the air door actuator/motor installation procedure?
A:
Install the left air temperature actuator, and the screws and tighten the screws to 2 N.m (18 Ib in). Next install the electrical connector, the I/P insulator panel, and the center console. Then reprogram the left air temperature actuator.
By BobGM Specialist
01/11/2022 Q: How to remove the air temperature actuator?
A:
The procedure is to remove the IP insulator, and the air temperature actuator, and disconnect the electrical connector.
By BobGM Specialist
01/11/2022 Q: How to avoid air door actuator damage?
A:
Don't apply power to the actuator when it is not installed in the HVAC module.
By BobGM Specialist
01/11/2022 Q: How to install the mode actuator?
A:
The procedure is to install the mode actuator, the mode actuator mounting screws, the center console duct, the screws, the center console, the floor air outlet duct extension, and connect the electrical connection.
By BobGM Specialist
01/11/2022 Q: Can I adjust any controls on the HVAC control module while the HVAC control module is self-calibrating?
A:
No, you may not. If interrupted, improper HVAC performance will result.
By BobGM Specialist
01/11/2022 Q: How to install the recirculation actuator?
A:
You can install the recirculation actuator, and the air distribution duct, and connect the electrical connector.
By BobGM Specialist
01/11/2022 Q: What is the removal procedure for the recirculation actuator?
A:
The procedure is to remove the air distribution duct, and the recirculation actuator, and disconnect the electrical connection.
By BobGM Specialist
01/11/2022 Q: What is the air door actuator installation procedure?
A:
Install the right air temperature actuator, and the screws and tighten the screws to 2 N.m (18 lb in). Next, connect the electrical connector and install the I/P carrier. Then reprogram the air temperature actuator.
By BobGM Specialist
01/11/2022 Q: What is the air door actuator/motor removal procedure?
A:
Remove the center console and the I/P insulator panel. Next disconnect the electrical connector. Then remove the screws and the left air temperature actuator.
By BobGM Specialist
01/11/2022 Q: What is the installation procedure for the recirculation actuator?
A:
The procedure is to install the recirculation actuator, and the air distribution duct, and connect the electrical connector.
By BobGM Specialist
01/11/2022 See more FAQs (9)