Part Description: 2002 Buick Rendezvous Rear Motor
More Info
Vehicle Fitment
2002 Buick Rendezvous | CX, CX Plus, CXL, CXL Plus, Ultra | 6 Cyl 3.4 L GAS, 6 Cyl 3.5 L GAS, 6 Cyl 3.6 L GAS
FAQ for Windshield Wiper Motors Repair
Q: How to remove the wiper motor cover?
A:
You will need to remove the wiper system drive module and the wiper motor cover screws, then remove the wiper motor cover from the wiper motor.
By Bob
GM Specialist
01/11/2022
Q: What should be noticed when you replace the wiper motor crank arm?
A:
The wiper motor crank arm is part of the wiper system drive module assembly and is not serviced separately.
By Bob
GM Specialist
01/11/2022
Q: What's the recommended torque for the rear wiper motor screws?
A:
The recommended torque is 6 N.m (53 lb in).
By Bob
GM Specialist
01/11/2022
Q: What's the recommended torque for the wiper motor cover screws?
A:
The recommended torque is 3 N.m (27 lb in).
By Bob
GM Specialist
01/11/2022
Q: What's the installation procedure for the rear wiper motor?
A:
The installation procedure is to connect the rear wiper motor electrical connector, position the rear wiper motor to the lift gate, and install the rear wiper motor screws, the lift gate access trim panel, the seal, and the rear wiper arm.
By Bob
GM Specialist
01/11/2022
Q: What should be noticed when you replace the wiper motor?
A:
The wiper motor is part of the wiper system drive module assembly and is not serviced separately.
By Bob
GM Specialist
01/11/2022
See more FAQs (1)
FAQ for Other Repair Info
Q: What's the installation procedure for the rear washer pump?
A:
The installation procedure is to position the rear Washer Pump to the washer solvent container and seat it, connect the rear hose to the rear washer pump, connect the rear washer pump electrical connector, fill the washer solvent container with washer solvent, and close the hood.
Q: What should be noticed when installing the wiper blade element?
A:
You will need to keep the Wiper Blade claws in the rubber claw channel of the wiper blade element and not allow the claws of the wiper blade to contact the metal spline of the wiper blade element.
Q: What's the installation procedure for the washer solvent container level sensor?
A:
The installation procedure is to and seats it fully, connect the washer solvent container level sensor electrical connector, fill the washer solvent container with washer solvent, then close the hood.