FAQ for Hvac Heater Blend Door Actuator Repair
Q: What's the recommended torque for the air temperature actuator mounting screws?
A:
The recommended torque is 1.6 N.m (14 lb in).
By BobGM Specialist
01/11/2022 Q: What's the recommended torque for the recirculation actuator mounting screws?
A:
The recommended torque is 1.6 N.m (14 lb in).
By BobGM Specialist
01/11/2022 Q: How do you remove the recirculation actuator?
A:
You can remove the upper IP trim pad, disconnect the recirculation actuator electrical connector, remove the mounting screws from the recirculation actuator, and remove the recirculation actuator.
By BobGM Specialist
01/11/2022 Q: What's the installation procedure for the air door actuator?
A:
The installation procedure is to install the mode actuator, install the mode actuator mounting screws, connect the IP wiring harness clip to the IP support bracket, connect the mode actuator push rod to the retainer clip, close the push rod retainer clip, connect the mode actuator electrical connector, install the knee bolster.
By BobGM Specialist
01/11/2022 Q: What's the recommended torque for the temperature door lever bolt installed in the HVAC module case?
A:
The recommended torque is 0.9 N.m (8 lb in).
By BobGM Specialist
01/11/2022 Q: What's the recommended torque for the knee bolster screws?
A:
The recommended torque is 2.5 N.m (22 lb in).
By BobGM Specialist
01/11/2022 Q: What's the recommended torque for the left-hand air temperature actuator mounting screws?
A:
The recommended torque is 1.6 N.m (14 lb in).
By BobGM Specialist
01/11/2022 Q: What's the recommended torque for the mode actuator mounting screws?
A:
The recommended torque is 1.6 N.m (14 lb in).
By BobGM Specialist
01/11/2022 Q: What's the recommended torque for the left-hand temperature door lever bolt?
A:
The recommended torque is 0.9 N.m (8 lb in).
By BobGM Specialist
01/11/2022 See more FAQs (4)