FAQ for Hvac Control Module Repair
Q: What is the recommended torque for the screws?
A:
The recommended torque is 2 Nm (23 lb in).
By BobGM Specialist
01/11/2022 Q: What is the installation procedure for the HVAC control module?
A:
The procedure is to connect the HVAC control module electrical connectors, install the HVAC control module, the HVAC control module fasteners, and the right IP cluster trim plate, and lastly recalibrate the actuators.
By BobGM Specialist
01/11/2022 Q: How to remove the air temperature switch assembly - right?
A:
You need to remove the right IP trim plate, and the two retaining screws from the right air temperature switch assembly, then remove the right air temperature switch assembly.
By BobGM Specialist
01/11/2022 Q: How to remove the HVAC control module?
A:
You need to remove the right IP cluster trim plate, and the fasteners that secure the HVAC control module, then pull the HVAC control module rearward and disconnect the HVAC control module electrical connectors.
By BobGM Specialist
01/11/2022 Q: How to remove the steering wheel HVAC control assembly?
A:
You need to remove the steering wheel, the three screws securing the rear cover, and the rear cover, then disconnect the HVAC control electrical connector and remove the HVAC control switch from the steering wheel.
By BobGM Specialist
01/11/2022 Q: What is the installation procedure for the air temperature switch assembly - right?
A:
The procedure is to install the right air temperature switch assembly into the trim plate, the screws, and the IP trim plate.
By BobGM Specialist
01/11/2022 Q: How to install the blower motor control processor?
A:
You need to install the blower motor control processor, install the screws, connect the blower motor control processor electrical connector, install the IP fuse/relay center, the IP storage compartment, and the right sound insulator.
By BobGM Specialist
01/11/2022 Q: What is the recommended torque for the rear cover screws?
A:
The recommended torque is 3 N.m (26.5 lb in).
By BobGM Specialist
01/11/2022 See more FAQs (3)