FAQ for Hvac Heater Blend Door Actuator Repair
Q: What's the recommended torque for the air temperature retaining screws?
A:
The recommended torque is 1.4 N.m (12 lb in).
By BobGM Specialist
01/11/2022 Q: What's the recommended torque for the passenger air mix retaining screws?
A:
The recommended torque is 1.4 N.m (12 lb in).
By BobGM Specialist
01/11/2022 Q: How to remove the right air temperature actuator?
A:
You will need to remove the IP compartment, disconnect the electrical connector from the air temperature actuator, and remove the air temperature actuator retaining screws and the air temperature actuator.
By BobGM Specialist
01/11/2022 Q: What's the recommended torque for the driver air mix retaining screws?
A:
The recommended torque is 1.4 N.m (12 lb in).
By BobGM Specialist
01/11/2022 Q: What's the recommended torque for the mode actuator retaining screws?
A:
The recommended torque is 1.4 N.m (12 lb in).
By BobGM Specialist
01/11/2022 Q: How to remove the mode actuator?
A:
You will need to remove the left sound insulator, the knee bolster, and the IPM, disconnect the electrical connector from the mode actuator and remove the mode actuator retaining screws and the mode actuator.
By BobGM Specialist
01/11/2022 Q: What's the recommended torque for the recirculation actuator retaining screws?
A:
The recommended torque is 1.4 N.m (12 lb in).
By BobGM Specialist
01/11/2022 Q: What's the proper way to install the air temperature actuator?
A:
The proper way is to install the air temperature actuator and the air temperature retaining screws, connect the electrical connector to the air temperature actuator, install the IP compartment and recalibrate the actuator.
By BobGM Specialist
01/11/2022 Q: How to remove the left air temperature actuator?
A:
You will need to remove the left-side sound insulator, the knee bolster, and the Instrument Panel Module (IPM), disconnect the electrical connector from the air temperature actuator and remove the air temperature actuator retaining screws and the air temperature actuator.
By BobGM Specialist
01/11/2022 Q: What's the recommended torque for the rear two DIM module bracket retaining screws?
A:
The recommended torque is 1.4 N.m (12 lb in).
By BobGM Specialist
01/11/2022 See more FAQs (5)