Notes: W/O Dual Climate Control; W/Dual Climate Control
Other Names: Control Module, Module
Item Dimensions: 6.6 x 4.3 x 4.2 inches
Item Weight: 0.80 Pounds
Fitment Type: Direct Replacement
Replaces: 52474881
Part Description: 2002 Buick LeSabre Module, Blower Motor Control
More Info
Vehicle Fitment
2002 Buick LeSabre | Custom, Limited | 6 Cyl 3.8 L GAS
FAQ for Hvac Control Module Repair
Q: What's the recommended torque for the retaining screw?
A:
The recommended torque is 2 N.m (18 lb in).
By Bob
GM Specialist
01/11/2022
Q: What's the installation procedure for the control assembly?
A:
The installation procedure is to install the passenger temperature control, ensure the tabs are seated into the switch plate, connect the electrical connector, and install the passenger window switch plate.
By Bob
GM Specialist
01/11/2022
Q: What's the removal procedure for the control assembly?
A:
The removal procedure is to remove the passenger window switch plate by prying up on the forward edge with a flat blade tool, disconnecting the electrical connector, and carefully pushing the tabs on the passenger temperature control to remove from the switch plate.
By Bob
GM Specialist
01/11/2022
Q: What's the removal procedure for the HVAC control module?
A:
The removal procedure is to remove the right IP accessory trim plate, pinch the tabs on the A/C control module and pull rearward on the heater and A/C control to remove from the instrument panel.
By Bob
GM Specialist
01/11/2022
Q: What's the installation procedure for the HVAC control module?
A:
The installation procedure is to install the heater and A/C control module into the instrument panel ensuring the tabs are seated into the IP and install the right IP accessory trim plate.
By Bob
GM Specialist
01/11/2022
Q: What's the recommended torque for the DIM bracket screws?
A:
The recommended torque is 1.4 N.m (12 lb in).
By Bob
GM Specialist
01/11/2022
See more FAQs (1)
FAQ for Other Repair Info
Q: What's the installation procedure for the upper left air temperature sensor?
A:
The installation procedure is to connect the electrical connector to the Air Temperature Sensor, install the air temperature sensor into the duct and twist it clockwise to lock it in place, and install the instrument panel end cap.
Q: What's the removal procedure for the heater hoses?
A:
The removal procedure is to drain the cooling system, remove the fuel injector sight shield, position the J 38185 to remove the Heater Hose clamps, remove the heater hoses from the heater core, then remove the heater hoses from the heater pipe adapters.
Q: How to remove the compressor control valve ASM?
A:
You will need to remove the control valve retaining ring using the J 5403, then remove the control valve assembly.