Part Description: 2000 Chevrolet K3500 Throttle Position Sensor
More Info
Vehicle Fitment
2000 Chevrolet K3500 | All Trims | 8 Cyl 5.7L
2000 Chevrolet K3500 | All Trims | 8 Cyl 7.4L
FAQ for Throttle Position Sensor Repair
Q: How to install the throttle position sensor?
A:
You need to install the TP sensor on the throttle shaft, the TP sensor attaching fasteners, and the TP sensor harness connector.
By Bob
GM Specialist
01/11/2022
Q: How to remove the throttle position sensor?
A:
You shall disconnect the throttle position (TP) sensor harness connector, and remove the TP sensor attaching fasteners, and the TP sensor from the throttle body assembly.
By Bob
GM Specialist
01/11/2022
FAQ for Other Repair Info
Q: How to install the throttle cable/linkage?
A:
You should install the accelerator cable to the dash panel, to the accelerator pedal, to the cable routing bracket, to the accelerator cable bracket, and the Throttle Body lever.
Q: How to remove the manifold absolute pressure (MAP) sensor?
A:
You shall disconnect the negative battery cable and the MAP Sensor harness connector, and remove the MAP sensor by pulling straight up with a slight rocking motion, and the MAP sensor grommet.
Q: How to remove the intake manifold-lower?
A:
You shall remove the upper radiator hose, both heater hoses, the water pump inlet hose, the distributor, the drive belt, the PCV valve, the power steering bracket, the valve rocker arm covers, and the Intake Manifold.