Part Description: 2000 Chevrolet K3500 Rack Seal Kit
More Info
Vehicle Fitment
2000 Chevrolet K3500 | Base, Cheyenne, LS, Scottsdale, Silverado | 8 Cyl 5.7 L GAS, 8 Cyl 6.2 L DIESEL, 8 Cyl 6.5 L DIESEL, 8 Cyl 7.4 L GAS
$33.59MSRP: $55.61
You Save: $22.02 (40%)
FAQ for Steering Gear Seals Repair
Q: How to install the steering gear seal?
A:
You need to install the seal, the washer, the snap ring, the power steering gear, the dust seal, the pitman shaft boot, and the pitman arm, and bleed the system.
By Bob
GM Specialist
02/11/2022
Q: How to remove the steering gear seal?
A:
You shall remove the power steering gear, the pitman arm from the pitman shaft, the pitman shaft boot, the dust seal, the snap ring, the pitman arm, the washer, and the seal.
By Bob
GM Specialist
02/11/2022
FAQ for Other Repair Info
Q: What should be noticed before installing the pitman's arm?
A:
If a clamp-type Pitman Arm is used, you shall spread the pitman arm just enough with a wedge to slip the arm onto the pitman shaft, and do not spread the pitman arm more than required to slip over the pitman shaft with hand pressure.
Q: How to remove the duo-servo drum brakes?
A:
You shall remove the linings, disconnect the brake pipe from the rear of the master cylinder, and remove the bolts and the Wheel Cylinder.
Q: How to install the vacuum brake booster hose?
A:
You shall route the hose in the same position as it was prior to removal, and install the hose to the fitting on the engine and the fitting on the Brake Booster.