Part Description: 2000 Chevrolet K3500 Arm Kit, Steering Linkage Idler
More Info
Vehicle Fitment
2000 Chevrolet K3500 | Base, Cheyenne, LS, Silverado | 8 Cyl 5.7 L GAS, 8 Cyl 6.2 L DIESEL, 8 Cyl 6.5 L DIESEL, 8 Cyl 7.4 L GAS
FAQ for Pitman Arm Repair
Q: What should be noticed before installing the pitman's arm?
A:
If a clamp-type pitman arm is used, you shall spread the pitman arm just enough with a wedge to slip the arm onto the pitman shaft, and do not spread the pitman arm more than required to slip over the pitman shaft with hand pressure.
By Bob
GM Specialist
02/11/2022
Q: What kind of tools will be required in the replacement of the pitman's arm?
A:
The tools required include J 24319-01 Universal Steering Linkage Puller, J 29107-A Universal Pitman Arm Puller, J 6632-01 Pitman Arm Puller, and J 29194 Steering Linkage Installer (14 mm).
By Bob
GM Specialist
02/11/2022
FAQ for Other Repair Info
Q: How to remove the tie rod?
A:
You shall remove the cotter pin at the ball stud, the nut from the ball stud, and the ball stud and Tie Rod End from the tie rod assembly.
Q: How to remove the idler arm?
A:
You shall suitably support the vehicle with jack stands, remove the Idler Arm frame bolts and the nuts, the idler arm ball stud nut, and the idler arm from the relay rod, and clean the threads on the ball stud.
Q: What should be noticed while removing the center link?
A:
You must not reuse the idler arm ball stud nut, and not reuse the Pitman arm nut.