Part Description: 2000 Chevrolet K3500 Hose Asm-Front Brake
More Info
Vehicle Fitment
2000 Chevrolet K3500 | Base, Cheyenne, LS, Scottsdale, Silverado | 8 Cyl 5.7 L GAS, 8 Cyl 6.2 L DIESEL, 8 Cyl 6.5 L DIESEL, 8 Cyl 7.4 L GAS
FAQ for Brake Hose Repair
Q: How to remove the front brake hose?
A:
You shall clean the hose fittings at both ends, disconnect the steel pipe, and remove the clip, the bolt and the washers, and the brake hose.
By Bob
GM Specialist
01/11/2022
Q: How to install the front brake hose?
A:
The proper way is to install the brake hose, the new copper washers, the bolt, and the clip, connect the steel pipe, and bleed the brakes.
By Bob
GM Specialist
01/11/2022
Q: What should be noticed while servicing the brake pipe?
A:
You shall always use double-walled steel brake pipe when replacing brake pipes. The use of any other pipe is not recommended and may cause a brake system failure. You shall carefully route and retain replacement brake pipes, and use the correct fasteners in the original location for replacement brake pipes.
By Bob
GM Specialist
01/11/2022
FAQ for Other Repair Info
Q: What should be noticed before installing the pitman's arm?
A:
If a clamp-type Pitman Arm is used, you shall spread the pitman arm just enough with a wedge to slip the arm onto the pitman shaft, and do not spread the pitman arm more than required to slip over the pitman shaft with hand pressure.
Q: How to install the leading/trailing drum brakes?
A:
The proper way is to install the Wheel Cylinder, the bolts, the inlet pipe, and the shoes and linings, and bleed the brake system.
Q: How to install the vacuum brake booster hose?
A:
You shall route the hose in the same position as it was prior to removal, and install the hose to the fitting on the engine and the fitting on the Brake Booster.