Part Description: 2000 Chevrolet Blazer Column Assembly
More Info
Vehicle Fitment
2000 Chevrolet Blazer | LS, LT, Trailblazer, Xtreme, ZR2 | 6 Cyl 4.3 L GAS
FAQ for Steering Column Repair
Q: What do I need to ensure before the shaft is rotated?
A:
You need to ensure that you remove the inflatable restraint coil assembly from the steering column and allow it to hang freely.
By Bob
GM Specialist
01/11/2022
Q: Under what circumstances do I need to replace the steering shaft?
A:
You need to replace the steering shaft if it shows sheared plastic.
By Bob
GM Specialist
01/11/2022
Q: Under what circumstances do I need to replace the jacket assembly?
A:
You need to replace the assembly if the bracket is welded to the jacket assembly.
By Bob
GM Specialist
01/11/2022
Q: How to check for jacket assembly collapse?
A:
You are recommended to measure the distance from the lower edge of the upper jacket to a defined point on the lower jacket. If measured dimensions are not within specifications, a new jacket must be installed.
By Bob
GM Specialist
01/11/2022
FAQ for Other Repair Info
Q: How to install the Pitman Arm?
A:
You need to install the Pitman Arm to the pitman arm shaft, then you need to install the pitman arm washer and nut to the pitman arm shaft. After that, you need to remove the power steering gear from the vise. Finally, you need to install the power steering gear.
Q: How to release the stud from the steering knuckle?
A:
You can carefully hammer on the Steering Knuckle in the area of the upper ball joint stud.
Q: How to install the Brake Drum?
A:
You need to locate the relationship mark and install the Brake Drum to the axle. Then you need to install the tire and wheel. After that, you should adjust the rear brakes. Finally, you need to remove the safety stands and lower the vehicle.