Part Description: 2000 Chevrolet Blazer Heater & Air Conditioner Control Blower Switch
More Info
Vehicle Fitment
2000 Chevrolet Blazer | Base, LS, LT, Trailblazer, Xtreme, ZR2 | 6 Cyl 4.3 L GAS
$10.77MSRP: $34.62
You Save: $23.85 (69%)
FAQ for Blower Motor Resistor Repair
Q: How long should we wait after applying the adhesive?
A:
You need to allow the adhesive to set for 15 minutes, or wait until the adhesive skins over.
By Bob
GM Specialist
01/11/2022
Q: What is the recommended torque for the blower motor resistor mounting screws?
A:
The recommended torque is 1.9 N.m (17 lb in).
By Bob
GM Specialist
01/11/2022
Q: How to remove the Blower Motor Resistor?
A:
You need to disconnect the electrical connector first. Then you need to remove the blower motor resistor mounting screws. Finally, you can remove the blower motor resistor from the blower case.
By Bob
GM Specialist
01/11/2022
Q: What is the recommended torque for the blower motor resistor mounting screw?
A:
The recommended torque is 1.9 N.m (17 lb in).
By Bob
GM Specialist
01/11/2022
Q: How to cut the access cover from the case?
A:
You can cut all four sides of the cover to remove the three attaching screws, then you can use a sharp utility knife to cut the case. You need to make the cuts straight and clean and make sure that the access cover must be reinstalled and visible to the customer.
By Bob
GM Specialist
01/11/2022
Q: How to install the Blower Motor Resistor?
A:
You need to install the blower motor resistor to the blower case, then you need to install the blower motor resistor mounting screws. Finally, you need to connect the electrical connector.
By Bob
GM Specialist
01/11/2022
See more FAQs (1)
FAQ for Other Repair Info
Q: What should I do before installing the outlet heater hose on the vehicle?
A:
You are recommended to apply lubricant, GM P/N 9985662, to each end of the outlet Heater Hose.
Q: Do I need a Cabin Air Filter service?
A:
No, this vehicle does not use a factory-installed Cabin Air Filter.
Q: How to remove the Blower Motor Relay?
A:
You need to disconnect the negative battery cable first, then you need to remove the Blower Motor relay from the retaining bracket. After that, you need to disconnect the electrical connector, then you can remove the Blower Motor Relay.