< Back ×
My Vehicle Change Vehicle
2000 Cadillac Escalade
< Back to View All
Ignition, Distributors & ECM
- Department
- Brands
- Prices
Cardone Reman® Remanufactured Vehicle Control Module for 2000 Cadillac Escalade
PartNumber: 77-3494FProduct Specifications- Notes: Knock Module must be removed from original PCM and installed in replacement PCM;with OE # 16263494;Vehicle specific Flash programming req'd ON or OFF the vehicle.Accurate VIN & mileage are req'd. Additional vehicle specific on-car programming must be performed AFTER installation to prevent drivability & starting issues.
- Connector/Terminal Configuration: Pin/Male, Pin/Male, Pin/Male, Pin/Male
- E-Waste: Yes
- Module Housing Material: Metal
- Product Condition: Remanufactured
- Part Description: Remanufactured Vehicle Control Module
$98.74
OEM (Genuine) 2000 Cadillac Escalade PCM
PartNumber: 9366810
Product Specifications- Notes: 5.7 Liter
- Other Names: Control Module, ECM, PCM
- Item Dimensions: 8.2 x 4.2 x 10.2 inches
- Item Weight: 6.40 Pounds
- Fitment Type: Direct Replacement
- Part Description: PCM
OEM (Genuine) 2000 Cadillac Escalade PCM
PartNumber: 16263494Product Specifications- Notes: All Models; 5.7l, 7.4l
- Other Names: ECM, PCM
- Item Dimensions: 10.8 x 8.2 x 4.1 inches
- Item Weight: 5.60 Pounds
- Fitment Type: Direct Replacement
- Part Description: PCM
FAQ for Engine Control Module Repair
Q: What is the proper way to install the vehicle control module (VCM)?
A:
The proper way is to align the notches of the knock sensor module with the notches in the socket. Install the knock sensor module in the socket, the knock sensor module access cover on the VCM, and the knock sensor module access cover screws. Connect the VCM harness connectors, install the VCM into the VCM bracket, fasten the VCM retainer clip and connect the negative battery cable.
By Bob
GM Specialist
01/11/2022Q: What is the removal procedure for the vehicle control module (VCM)?
A:
You need to disconnect the negative battery cable and remove the VCM retainer clip, the VCM from the VCM bracket, the VCM harness connectors, the knock sensor module access cover screws, and the knock sensor module access cover. Then gently pinch the retaining clip and pull upward to remove the knock sensor module.
By Bob
GM Specialist
01/11/2022Q: What should I do when the VCM fails to program?
A:
You need to check all the VCM connections. Check the ITCS terminal and equipment for the latest software version. Try again to program the VCM. If the programming fails again, replace the VCM.
By Bob
GM Specialist
01/11/2022