FAQ for Alloy Wheels Repair
Q: How do you install and reprogram the tire pressure monitor receiver?
A:
To install and reprogram the tire pressure monitor you must install new tire/wheel assemblies, reprogram the control modules for the new tire/wheels, reset tire type and pressure, and set the inflation pressure of each tire.
By OmarGM Specialist
03/12/2020 Q: How do you properly clean a tire?
A:
You properly clean a tire with a liner cleaner, cloth, and a scraper to remove dirt and debris.
By BobGM Specialist
03/12/2020 Q: How is the spare tire different than other tires?
A:
Spare tires are different than other tires because they fit in the storage room with ease and don't weigh as much. Even though the spare tire has a size difference they travel the same distances as other tires and should not cause any concerns.
By BobGM Specialist
03/12/2020 Q: How do you clean the puncture mark?
A:
You clean the puncture site by using a hand reamer and reaming the puncture to be able to fill the hole.
By BobGM Specialist
02/12/2020 Q: Does the wheel/tire need to be rebalanced after getting the wheel repaired?
A:
Yes, the wheel will need to be rebalanced to avoid premature wear on the tires.
By OmarGM Specialist
02/12/2020 Q: How can a leaking wheel be fixed?
A:
Aleaking wheel will require the wheel and tire to be removed from the vehicle. You will need to locate the leaking area and look to see if the wheel is bent or if it's a bad tire. If you determine the leak is coming from the wheel area, you will need to dismount the tire from the wheel. The rim will need to be scuffed so that the affected area is fixed. Apply tire silicone or sealant to the wheel where the affected area was repaired and mount the wheel back on the tire.
By BobGM Specialist
02/12/2020 Q: What happens after filling and repairing the puncture?
A:
After repairing the puncture, you will need to buff the area so you can add cement. Then, put the tire back on the wheel and use a tire safety cage to ensure the tire has been repaired properly and no air is escaping.
By OmarGM Specialist
02/12/2020 Q: What are the three main steps of tire puncture repair?
A:
The three basic steps are removing and inspecting the tire, filling the puncture, and sealing the inner liner to prevent air loss.
By OmarGM Specialist
02/12/2020 Q: What benefits does using nitrogen gas on vehicles have?
A:
It helps with the reduction in the loss of tire pressure, in the variance of tire pressures with temperature changes, and long-term rubber degradations decrease due to oxygen concentrations.
By BobGM Specialist
02/12/2020 Q: What are some areas that should be checked before getting a wheel balanced?
A:
Before getting a wheel balanced it is important to check for missing balance weights, bent rims, tire wear, bead seating, stones in the tire tread, and tire irregularities.
By OmarGM Specialist
02/12/2020 See more FAQs (13)