Part Description: 2011 Chevrolet Suburban 2500 Converter & Pipe
More Info
Vehicle Fitment
2011 Chevrolet Suburban 2500 | LS, LT | 8 Cyl 6.0 L FLEX, 8 Cyl 6.0 L GAS
FAQ for Exhaust Pipe Repair
Q: What causes an exhaust leak or noise?
A:
This may be caused due to an unseated pipe to pipe mid-joint.
By Bob
GM Specialist
03/10/2021
Q: How do you ensure that the pipe flares remain fully seated to each other while clamping?
A:
To ensure that the pipe flares remain fully seated while clamping you must do the following: Remove and discard the exhaust band clamp, install and position a new exhaust band clamp to the pipe joint, firmly push and maintain the pipes together while tightening, confirm that the clamp edges are fully seated on the pipe, run the engine and inspect the clamp to ensure no leaks.
By Bob
GM Specialist
02/10/2021
Q: How do you fix a muffler buzz?
A:
Raise and support the vehicle, mark the position of the heat shield and straps, cut and remove the heat shield straps, position the heat shield to the muffler and install new heat shield straps on the muffler shell in the positions marked, position the strap screw heads and cut off excess strap material.
By Omar
GM Specialist
02/10/2021
Q: What causes the Pinging/popping/snapping noise from the exhaust system?
A:
The pinging/popping/snapping noise is due to the exhaust system cooling down and is normal for this exhaust system.
By Bob
GM Specialist
31/12/2020
FAQ for Other Repair Info
Q: How many nuts and bolts does the transmission mount and transmission crossmember have?
The Oil Filter should be changed every time you change your oil.
Q: If water is found in the transmission what components must be replaced?
A:
If water is found in the transmission, the rubber seals, clutch plates and bands, nylon parts, and torque converter need to be replaced. Also, make sure to thoroughly clean the transmission/transmission case so no water is left behind.