Other Names: Composite Assembly, Headlamp Assembly
Item Dimensions: 24.7 x 16.2 x 12.5 inches
Item Weight: 4.90 Pounds
Fitment Type: Direct Replacement
Part Description: 2011 Chevrolet HHR Composite Assembly
More Info
Vehicle Fitment
2011 Chevrolet HHR | LS, LS Panel, LT, LT Panel, SS, SS Panel | 4 Cyl 2.0 L GAS, 4 Cyl 2.2 L FLEX, 4 Cyl 2.2 L GAS, 4 Cyl 2.4 L FLEX, 4 Cyl 2.4 L GAS
$108.98MSRP: $164.42
You Save: $55.44 (34%)
FAQ for Headlight Repair
Q: If the lens gets damaged, can the lens be bought separately?
A:
No, avoid damage to the lens as the lens is only sold with the whole headlight assembly.
By Bob
GM Specialist
09/11/2021
Q: Can Polycarbonate lenses be washed with car wash soap?
A:
Yes, the lens can be washed with car wash soap but you must make sure it's not highly concentrated in certain chemicals which may degrade the life of the headlight.
By Omar
GM Specialist
04/11/2021
FAQ for Other Repair Info
Q: What if the airbag readiness light flashes for a few seconds, and then turns off?
A:
If the airbag readiness light flashes for a few seconds when the engine is started and then turns off, refer to SDM Programming in this bulletin. Submit a claim using the published labor operation code provided in this field action bulletin.
Q: Where is the floor console fuse block located?
A:
The floor console fuse block is located on the passenger seat side of the floor console behind the forward panel.
Q: What is the installation procedure?
A:
Drill 8 mm plug weld holes in the service part as necessary in the locations noted from the original panel. Apply 3M Weld-Thru coating P/N 05916. Position the battery tray on the vehicle. Plug weld accordingly. Clean and prepare all of the welded surfaces. Install all of the related panels and components. Apply the sealers and paint the required area. Connect the negative battery table. Enable the SIR system.