Material: Heavy gauge steel pressure tube provides long life; Rubber o-ring piston seal for controlled lift; Teflon backup ring gives enhanced performance
Shaft: 8.00
SHAFT CONNECTION: ball socket (nylon) 10mm
Stroke: 3.50
UPC: 845998005459
Part Description: 2011 Chevrolet Corvette Hood Lift Support
Part Description: 2011 Chevrolet Corvette Max-Lift™ Hood Lift Support
More Info
Vehicle Fitment
2011 Chevrolet Corvette | All Trims | All Engines
FAQ for Hood Lift Support Repair
Q: How many ball studs does the assist rod need?
A:
The assist rod has a total of 2 ball studs.
By Bob
GM Specialist
05/12/2021
Q: Do I need alternate support when a hood-hold-open device is being used?
A:
Yes. Always provide alternate support when a hood hold open device is being removed or installed, to avoid the possibility of personal injury or damage to the vehicle.
By Bob
GM Specialist
04/12/2021
FAQ for Other Repair Info
Q: What is the procedure to replace a wheelhouse extension?
A:
Start by removing the overlapping plastic retainer from the front wheelhouse liner, and remove the appropriate lower valence panel piece.
Q: What is the hood primary latch release installation procedure?
A:
Route the cables through the opening in the dash panel, install the screws which mount the hood release handle, and install the cable grommet. Connect the cables to the latches, install the hood latches, and verify the operation latches.
Q: How many bolts hold the lower and upper hinge in place?
A:
There are 4 bolts holding the lower hinge and 4 bolts holding the upper hinge in place, 8 total bolts.