< Back ×
My Vehicle Change Vehicle
2011 Buick Lucerne
< Back to View All
Hoods
- Department
- Prices
OEM (Genuine) 2011 Buick Lucerne Latch
PartNumber: 20815645
Product Specifications- Other Names: Latch, Lock
- Item Dimensions: 9.1 x 5.6 x 4.6 inches
- Item Weight: 1.00 Pounds
- Fitment Type: Direct Replacement
- Replaces: 25795316, 15817924
- Part Description: 2011 Buick Lucerne Latch
Vehicle Fitment- 2011 Buick Lucerne | CX, CXL, CXL Special Edition, CXS, Super | 6 Cyl 3.8 L GAS, 6 Cyl 3.9 L FLEX, 6 Cyl 3.9 L GAS, 8 Cyl 4.6 L GAS
$205.74 MSRP:$323.56You Save: $117.82 (37%)
OEM (Genuine) 2011 Buick Lucerne Latch
PartNumber: 20906015
Product Specifications- Notes: W/Auto Start
- Other Names: Latch
- Item Dimensions: 8.1 x 5.7 x 5.5 inches
- Item Weight: 1.50 Pounds
- Fitment Type: Direct Replacement
- Replaces: 25794830, 15895471, 20763599, 25768922
- Part Description: 2011 Buick Lucerne Latch
Vehicle Fitment- 2011 Buick Lucerne | CX, CXL, CXL Special Edition, CXS, Super | 6 Cyl 3.8 L GAS, 6 Cyl 3.9 L FLEX, 6 Cyl 3.9 L GAS, 8 Cyl 4.6 L GAS
$110.01 MSRP:$165.98You Save: $55.97 (34%)
FAQ for Hood Latch Repair
Q: How do you properly remove the hood hinge bracket?
A:
Mark the location of the current hinge bracket. Drill out all factory welds and remove the damaged hood hinge bracket. Make sure the surfaces are clean of sealants and debris.
By Omar
GM Specialist
12/10/2021Q: How do you properly install a new hood hinge bracket?
A:
Clean the surface where the new bracket will be applied to. Drill out 21/64 in pivot holes so the 5/16 in plug weld holes are in the same position as factory welds. Apply weld through primer and position the bracket. Plug weld in 1in stitch weld pattern and apply sealants or anti-corrosion primer to the panel.
By Omar
GM Specialist
12/10/2021Q: How many bolts hold the hood latch in place?
A:
The hood latch is held in place by 3 bolts.
By Bob
GM Specialist
12/10/2021Q: How many bolts hold the hood latch support in place?
A:
The hood latch support is held in place by 4 bolts.
By Omar
GM Specialist
12/10/2021Q: What parts will need to be removed?
A:
The front impact bar, front bumper, and hood latch will need to be removed.
By Omar
GM Specialist
11/10/2021Q: Will any wires need to be disconnected?
A:
You will need to disconnect the release cable and the electrical connector for the remote start module (if equipped).
By Bob
GM Specialist
11/10/2021Q: What panels need to be removed to get access to the hood hinge?
A:
The hood insulator and hood will need to be removed to get access to the hood hinges.
By Bob
GM Specialist
11/10/2021See more FAQs (2)