2011 Buick Lucerne | CX, CXL, CXL Special Edition, CXS, Super | 6 Cyl 3.8 L GAS, 6 Cyl 3.9 L FLEX, 6 Cyl 3.9 L GAS, 8 Cyl 4.6 L GAS
1-30 of 35 Results
< Previous
12
Next >
FAQ for Brake Pad Set Repair
Q: When the brake pedal is applied can noise be heard?
A:
If the problem is noise, perform a vehicle inspection of the brake rotors and pads. If the pads are unevenly worn from side to side or inner to outer, replace the brake pads. If the brake pads are not worn, burnish brakes by performing 10-15 stops from 35-40 mph drives. Please allow cooling times in between stops.
By Omar
GM Specialist
11/10/2021
Q: When the brake pedal is applied can a pulsation be felt?
A:
If the problem is pulsations being felt, use the parking brake to determine if the issue is within the front rotors or the rear rotors. If the pulsation continues, clean up or refinish the rotors. If the rotors will be refinished please take measurements of the rotor thickness before and after the process.
By Bob
GM Specialist
11/10/2021
FAQ for Other Repair Info
Q: What are some areas that should be checked before getting a wheel balanced?
A:
Before getting a wheel balanced it is important to check for missing balance weights, bent rims, tire wear, bead seating, stones in the tire tread, and tire irregularities.
Q: How do you properly remove and install a new power steering line/hose?
A:
You will need to remove the negative battery cable and locate the underhood electrical center. Once located, examine the cable and wires. If the cable is tangled and twisted remove the cable and push it under the power steering line and bracket. Reinstall the cable to the electrical stud and ensure the line and cable are not coming in contact.