FAQ for Tie Rod End Repair
Q: What is the recommended torque for the Steering Linkage Outer Tie Rod nut?
A:
The recommended torque is 75 Nm (55 lb-ft).
By BobGM Specialist
01/11/2022 Q: How many rear axle tie rod mounting bolts does Rear Axle Tie Rod have?
A:
It has a total of 2 rear axle tie rod mounting bolts.
By BobGM Specialist
01/11/2022 Q: How to remove the Steering Linkage Inner Tie Rod?
A:
You can remove the steering gear boot, place a pipe wrench on the flats on the steering gear rack next to the steering linkage inner tie rod, place a wrench on the flats of the steering linkage inner tie rod, rotate the steering linkage inner tie rod counterclockwise while holding the steering gear rack stationary until the steering linkage inner tie rod separates from the steering gear rack.
By BobGM Specialist
01/11/2022 Q: What is the preliminary procedure for the Steering Linkage Outer Tie Rod removal?
A:
You can remove the front tire and wheel assembly.
By BobGM Specialist
01/11/2022 Q: What is the recommended torque for the steering linkage inner tie rod?
A:
The recommended torque is 150 Nm (111 lb-ft).
By BobGM Specialist
01/11/2022 Q: What should I notice in Steering Linkage Inner Tie Rod removal procedure?
A:
After removing the steering gear boot, inspect the steering linkage inner tie rod for evidence of corrosion or contamination. If none is evident, continue with the repair. If corrosion or contamination is evident, replace the steering gear. The appropriate flats on the steering gear rack are only present on the driver's side of the vehicle. If the passenger side steering linkage inner tie rod must be replaced then the steering gear boot must be removed from the driver's side as well to hold the steering gear rack from rotating. Replacing the passenger side steering linkage inner tie rod will require two people, one to hold the steering gear rack and one to install the steering linkage inner tie rod.
By BobGM Specialist
01/11/2022 Q: What should I notice in Steering Linkage Inner Tie Rod installation procedure?
A:
All threads must be cleaned before LOCTITE(R) application. Check the LOCTITE(R), or equivalent, the container for the expiration date. Use only enough LOCTITE(R) to evenly coat the threads.
By BobGM Specialist
01/11/2022 Q: What is the recommended torque for the Steering Linkage Inner Tie Rod nut?
A:
The recommended torque is 60 Nm (44 lb-ft).
By BobGM Specialist
01/11/2022 Q: What is the preliminary procedure for the Rear Axle Tie Rod removal?
A:
You can raise and support the vehicle.
By BobGM Specialist
01/11/2022 Q: How to install the Steering Linkage Inner Tie Rod?
A:
You can apply LOCTITE(R) 262, or equivalent, to the steering gear inner tie rod threads, attach the steering linkage inner tie rod onto the steering gear rack, place a pipe wrench on the flats on the steering gear rack next to the steering linkage inner tie rod, install the steering gear boot.
By BobGM Specialist
01/11/2022 See more FAQs (5)