2010 GMC Yukon Starter

The recommended torque is 9 Nm (80 lb in).

You can disconnect the negative battery cable, remove the oil pan skid plate, the transmission cover bolt, and the starter bolts, disconnect the engine wiring harness electrical connector, slide the starter forward until the starter clears the transmission and properly support the starter, remove the right front wheel and tire, remove the engine wiring harness lead nut, the engine wiring harness lead terminal, the starter solenoid cable clip bolt, the starter solenoid cable nut, the starter solenoid cable, the starter through the wheel well opening. If replacing the starter, unsnap the transmission cover from the starter. If replacing the starter, remove the starter heat shield.

If the starter was replaced, install the starter heat shield. If the starter was replaced, snap the transmission cover onto the starter. You can install the starter through the wheel well opening, the starter solenoid cable to the starter, the starter solenoid cable nut, position the starter solenoid cable clip to the frame and install the starter solenoid cable clip bolt, install the engine wiring harness lead terminal, the engine wiring harness lead nut, position the starter into place, install the starter bolts, and the right front wheel and tire, connect the engine wiring harness electrical connector, install the transmission cover bolt, the oil pan skid plate, connect the negative battery cable.