2010 GMC Yukon Power Steering Reservoir

The recommended torque is 58 Nm (44 lb-ft).

You should use a clean, new power steering fluid type only. See the Maintenance and Lubrication subsection for fluid specifications, hoses touching the frame, body, or engine may cause system noise, verify that the hoses do not touch any other part of the vehicle. The power steering fluid level must be maintained throughout the bleed procedure. With hydro-boost only, the oil level will appear falsely high if the hydro-boost accumulator is not fully charged. You do not apply the brake pedal with the engine OFF. This will discharge the hydro-boost accumulator.

You can remove the power steering pump assembly, the power steering fluid reservoir studs, the power steering pump fitting, the power steering pump fitting seal, the power steering pump flow control valve and the power steering pump flow control valve spring, the power steering pump seals, the power steering fluid reservoir magnet.

The recommended torque is 75 Nm (55 lb-ft).

You can install the power steering pump assembly, the power steering fluid reservoir studs, the power steering pump fitting, the power steering pump fitting seal, the power steering pump flow control valve and the power steering pump flow control valve spring, the power steering pump seals, the power steering fluid reservoir magnet.