2010 GMC Yukon Ignition Lock Cylinder

You can remove the inflatable restraint steering wheel module coil, and the ignition/start switch, disconnect the park lock cable from the ignition lock cylinder case, disconnect the passlock and key buzzer from the ignition lock cylinder case, remove the 3 ignition lock cylinder case screws, the ignition lock cylinder case.

You can use a screwdriver to rotate the ignition lock cylinder case gear clockwise to the start position-allowing it to spring return into the RUN position, install the key into the ignition lock cylinder, and the steering column shroud, and enable the SIR system.

You can disable the SIR system, remove the steering column shroud, an Allen wrench into the hole on top of the ignition lock cylinder case, and slide the ignition lock cylinder out of the ignition lock cylinder case.

The recommended torque is 7 Nm (62 lb in).

You can install the 3 ignition lock cylinder case screws, the ignition lock cylinder case, and the park lock cable into the lock cylinder housing, connect the passlock and key buzzer to the ignition lock cylinder case, install the ignition/start switch, the inflatable restraint steering wheel module coil.