FAQ for Hvac Heater Blend Door Actuator Repair
Q: What should be done before servicing the Air Inlet Valve Actuator?
A:
You should remove the inflatable restraint instrument panel (I/P) module and then disconnect the electrical connector from the recirculation actuator.
By BobGM Specialist
01/11/2022 Q: What is the recommended torque for the mode actuator screws?
A:
The recommended torque is 1.6 N.m (14 lb in).
By BobGM Specialist
01/11/2022 Q: What should be done before servicing the Mode Valve Actuator?
A:
You should remove the knee bolster, remove the air outlet duct - floor left hand (LH), and then disconnect the electrical connector from the mode actuator.
By BobGM Specialist
01/11/2022 Q: How many screws attach to the Mode Actuator?
A:
There are 2 screws attached to the Mode Actuator.
By BobGM Specialist
01/11/2022 Q: How many screws attach to the Air Temp Actuator screws?
A:
There are 2 screws attaching the Air Temp Actuator.
By BobGM Specialist
01/11/2022 Q: What is the recommended torque for the Air Temp Actuator screws?
A:
The recommended torque is 1.6 N.m (14 lb in).
By BobGM Specialist
01/11/2022 Q: How many screws attach to the Recirculation Actuator?
A:
There are 2 screws attached to the Recirculation Actuator.
By BobGM Specialist
01/11/2022 Q: What should be done before servicing the Temperature Valve Actuator?
A:
You should remove the inflatable restraint panel module and then disconnect the electrical connector from the air temp actuator.
By BobGM Specialist
01/11/2022 See more FAQs (3)