2010 GMC Sierra 3500 HD Air Bag Clockspring

You should remove the steering wheel, remove the steering wheel, disconnect any electrical connectors as needed, remove the inflatable restraint steering wheel module coil retaining ring, remove the inflatable restraint steering wheel module coil retaining ring and then discard the old inflatable restraint steering wheel module coil.

You should verify that the front wheels of the vehicle are in the straight-ahead position, verify that the block tooth of the steering shaft assembly is in the 12 o'clock position, verify that the ignition switch is in the lock position, remove the wire harness strap or straps where necessary, hold the supplemental inflatable restraint (SIR) coil and look at the side, rotate the coil hub clockwise, rotate the coil hub slowly counterclockwise approximately 3.3 turns, use the lock pin to lock the SIR coil in the center position, align the SIR coil and then route the wires up against the steering column.

You should align the inflatable restraint steering wheel module coil, connect any electrical connectors as needed, install the steering column shroud and then install the steering wheel.