2010 GMC Canyon | SL, SLE, SLT, WT | 4 Cyl 2.9 L GAS, 5 Cyl 3.7 L GAS, 8 Cyl 5.3 L GAS
$297.92MSRP: $561.14
You Save: $263.22 (47%)
FAQ for Engine Control Module Repair
Q: How to install the Engine Control Module?
A:
You need to install the ECM into the ECM mounting bracket and connect the ECM into the ECM mounting brackets to the ECM body. Then if a new ECM is being installed, the ECM must be programmed. Finally, if equipped with a manual transmission, perform the clutch pedal position sensor learn procedure.
By Bob
GM Specialist
01/11/2022
Q: How to remove the Engine Control Module?
A:
You need to retrieve the percentage of remaining engine oil and record the remaining engine oil life. Then you need to disconnect the ECM harness connectors from the ECM. Finally, you can disengage the ECM bracket mounting tabs, while removing the ECM.
By Bob
GM Specialist
01/11/2022
FAQ for Other Repair Info
Q: How to remove the Ignition Coil?
A:
You need to remove the air cleaner resonator and outlet duct and disconnect the engine wiring harness electrical connectors from the Ignition Coils. Then you need to remove the ignition coil bolts. Finally, you can remove the ignition coils from the camshaft cover.
Q: How to install the Ignition Lock Cylinder Case?
A:
You need to install the Ignition Lock Cylinder and install the steering column trim covers.
Q: How to remove the Knock Sensor?
A:
You need to raise and support the vehicle and remove the left wheelhouse liner. Then you need to disconnect the engine wiring harness electrical connector and remove the KS retaining bolt. Finally, you can remove the KS from the engine block.