Notes: Reverse Rotation; Severe Duty Thermal Fan Clutch
Bolt Hole Quantity: 4
Bolt Quantity: 4
Bolt Thread: M8x1.250
Clutch Maximum Diameter: 7.21875; 7.23
Clutch Type: D - Severe Duty & Truck Fan Drive
Color: Raw Aluminum in Color
Distance From Clutch To Mounting Flange: 0.59; 0.6
Electronic Clutch: No
Fan Bolt Circle IN: 3.8
Fan Bolt Circle MM: 96.6
Material: Aluminum
Meets / Exceeds OEM: Yes
Mount Dia. IN: 1.53 (39mm) HEX
Mount Dia. MM: 39 HEX
Mounting Hardware: Not Included
Mounting Hole Quantity: 4
Mounting Type: Threaded Shaft
New or Reman: New
Overall Dia. MM: 183.6
Overall Height IN: 7.22
Overall Height MM: 183.4
Performance Rated: Yes
Pilot Depth IN: 0.72
Pilot Depth MM: 18.3
Pilot Dia. IN: 1.5
Rotation: REV
SDS Required: No (135233618)
Style: Severe Duty
UPC: 096361460928
Use Type: Severe
Part Description: 2010 GMC Canyon Reverse Rotation Severe Duty Thermal Fan Clutch
More Info
Vehicle Fitment
2010 GMC Canyon | All Trims | 8 Cyl 5.3L
FAQ for Cooling Fan Clutch Repair
Q: How to install the Fan Clutch?
A:
You need to assemble the fan to the fan clutch, install the 4 bolts to the fan blade, and install the cooling fan.
By Bob
GM Specialist
01/11/2022
Q: What is the recommended torque for the bolts to the fan blade?
A:
The recommended torque is 27 Nm (20 lb-ft).
By Bob
GM Specialist
01/11/2022
Q: How to remove the Fan Clutch?
A:
You need to remove the cooling fan and remove the bolts retaining the fan blade to the fan clutch. Then you can separate the fan blade from the fan clutch.
By Bob
GM Specialist
01/11/2022
FAQ for Other Repair Info
Q: How to remove the Radiator Support?
A:
You need to disable the SIR system, disconnect the negative battery cable, and remove all related panels and components. Then you need to restore as much of the damage as possible to factory specification, and you need to note the location and remove the sealers and anti-corrosion materials from the repair area, as necessary. After that, you need to locate and drill out all factory welds. Finally, you need to remove the damaged Radiator support.
Q: How to remove the Water Pump?
A:
You need to drain the cooling system and remove the fan and the drive belt. Then you need to secure the Water Pump pulley and remove the water pump pulley bolts and the J 46406. After that, you need to remove the water pump pulley, the water pump bolts, and the water pump. Finally, you need to discard the gasket.
Q: How to install the Radiator Outlet Hose?
A:
You need to install the outlet Radiator Hose to the radiator and reposition the outlet radiator hose clamp to the radiator. Then you need to lower the vehicle and install the outlet radiator hose to the thermostat. After that, you need to reposition the outlet radiator hose clamp to the thermostat housing. Finally, you need to fill the cooling system.