2010 GMC Canyon Accelerator Pedal Position Sensor

You need to position the APP sensor over the studs. Then you need to install the APP sensor nuts and connect the APP sensor electrical connector. Finally, you need to inspect the pedal for binding, to ensure the full range of motion.

You need to remove the left front seat and access the sensor through the service slit provided on the carpet. Then you need to disconnect the longitudinal accelerometer electrical connector. After that, you need to remove the nuts from the longitudinal accelerometer. Finally, you can remove the longitudinal accelerometer.

The recommended torque is 9 Nm (80 lb in).

You need to install the longitudinal accelerometer and install the longitudinal accelerometer nuts. Then you need to connect the longitudinal accelerometer electrical connector. Finally, you need to install the left front seat.

You need to disconnect the accelerator pedal position (APP) sensor electrical connector. Then you need to remove the APP sensor nuts. Finally, you can remove the APP sensor from the vehicle.