Part Description: 2010 Chevrolet Traverse Valve Seals
More Info
Vehicle Fitment
2010 Chevrolet Traverse | High Country, L, LS, LT, LTZ, Premier, RS | 4 Cyl 2.0 L GAS, 6 Cyl 3.6 L GAS
$28.58MSRP: $47.33
You Save: $18.75 (40%)
FAQ for Valve Stem Oil Seal Repair
Q: What should be noticed while removing the valve stem oil seal and valve spring-left side?
A:
If EN 46106 is not installed, the crankshaft may rotate. If the crankshaft rotates, disassembly and reassembly of the entire camshaft timing system may be required.
By Bob
GM Specialist
01/11/2022
Q: How to remove the valve stem oil seal and valve spring-right side?
A:
You shall remove the starter motor, the camshafts and rocker arms, the spark plug from the applicable cylinder, the valve keepers, the valve spring retainer, the valve springs, and the valve stem seal.
By Bob
GM Specialist
01/11/2022
Q: How to install the valve stem oil seal and valve spring-right side?
A:
You shall install the valve stem seals, the valve spring, the valve spring retainer, the valve spring keepers, the spark plugs, the rocker arms and camshafts, and the starter motor.
By Bob
GM Specialist
01/11/2022
Q: What kind of tools will be required in the replacement of the valve stem oil seal and valve spring-left side?
A:
The tools required include EN 46106 Flywheel Holding Tool, EN 46110 On-Vehicle Valve Spring Compressor, EN 46116 Valve Stem Seal Remover/Installer, and J 39313 Spark Plug Port Adapter.
By Bob
GM Specialist
01/11/2022
Q: What are the valve stem oil seal and valve spring installation procedures?
A:
First, install the valve spring, the valve spring retainer, and the valve spring keepers. Install the spark plugs, the rocker arms/camshafts, and the starter motor.
By Omar
GM Specialist
04/03/2022
FAQ for Other Repair Info
Q: What should be noted when servicing the valve lifter?
A:
You shall ensure each Valve Lifter is filled with clean engine oil and the valve lifter does not tip over (plunger down) before the installation of the valve lifters.
Q: How to install the valve stem oil seal and valve spring-left side?
A:
You shall install the valve stem seal, the Valve Spring, the valve spring retainer, the valve spring keepers, the spark plugs, the rocker arms and camshafts, and the starter motor.
Q: How to remove the valve rocker arm-right side?
A:
You shall remove the applicable camshaft(s) and the Rocker Arms, and clean and inspect the camshaft(s) and the rocker arm(s).