Part Description: 2010 Chevrolet Traverse TPMS Sensor
More Info
Vehicle Fitment
2010 Chevrolet Traverse | All Trims | All Engines
FAQ for TPMS Sensor Repair
Q: How to install the tire pressure indicator sensor?
A:
You shall position the sensor body parallel to the inside wheel surface and install the tire and the tire/wheel assembly.
By Bob
GM Specialist
02/11/2022
Q: What should be noticed while removing the tire valve stem grommet?
A:
If any tire sealant is noted upon tire dismounting, you shall replace the sensor, also remove all residual liquid sealant from the inside of the tire and wheel surfaces.
By Bob
GM Specialist
02/11/2022
Q: How to remove the tire pressure indicator sensor?
A:
You shall remove the tire/wheel assembly from the vehicle, the tire from the wheel, the tire pressure sensor nut, and the tire pressure sensor.
By Bob
GM Specialist
02/11/2022
Q: What is the recommended torque for the sensor nut?
A:
The recommended torque is 7 N.m (62 lb in).
By Bob
GM Specialist
02/11/2022
Q: What is the tire pressure indicator sensor installation procedure?
A:
Insert the sensor in the wheel hole with the air passage facing away from the wheel, install the sensor nut and position the sensor body parallel to the inside wheel surface. Tighten the sensor nut and tighten it to 7 Nm. Install the tire on the wheel and the tire/wheel assembly on the vehicle.
By Bob
GM Specialist
04/03/2022
Q: What is the tire valve stem grommet installation procedure?
A:
Install the grommet on the sensor valve stem and insert the sensor in the wheel hole with the air passage facing away from the wheel. Install the sensor nut and position the sensor. Body parallel to the inside wheel surface while torquing. Tighten the sensor nut to 7 Nm.
By Omar
GM Specialist
04/03/2022
See more FAQs (1)
FAQ for Other Repair Info
Q: How to remove the starter?
A:
You shall remove the left catalytic convertor, the Starter heat shield bolt and shield, the battery positive junction block cable terminal from the starter, and the starter bolts and starter.
Q: How to service the park and turn signal bulb?
A:
You shall pull the bulb straight from the lamp assembly bulb socket.
Q: How to install the rear object sensor?
A:
You shall paint the rear object sensor, ensure the paint does not exceed 6 mils, insert the sensor into the housing, connect the electrical connector to the rear object sensor, and install the rear bumper fascia.