Part Description: 2010 Chevrolet Traverse Rear Passenger Side Brake Hydraulic Hose
Vehicle Fitment
2010 Chevrolet Traverse | All Trims | All Engines
FAQ for Brake Hose Repair
Q: How to install the rear brake hose?
A:
You shall assemble the brake hose fitting bolt and 2 new brake hose fitting gaskets to the brake hose, the brake hose assembly to the caliper, the brake hose bracket bolt, and the tire and wheel assembly.
By Bob
GM Specialist
01/11/2022
Q: How to install the power brake booster vacuum check valve and hose?
A:
You shall install the power brake booster check valve with a vacuum sensor and hose assembly, the fuel injector sight shield, and the windshield washer solvent heater.
By Bob
GM Specialist
01/11/2022
Q: How to remove the power brake booster vacuum check valve and hose?
A:
You shall remove the windshield washer solvent heater and the fuel injector sight shield, disconnect the power vacuum brake booster hose from the intake manifold vacuum port, the power brake booster vacuum sensor electrical connector, and the power brake booster check valve with a vacuum sensor and hose assembly from the brake booster, and remove the vacuum brake booster hose assembly.
By Bob
GM Specialist
01/11/2022
Q: What should be noted when removing the brake pipe?
A:
You shall always use double-walled steel brake pipe when replacing brake pipes, carefully route and retain replacement brake pipes, and always use the correct fasteners and the original location for replacement brake pipes.
By Bob
GM Specialist
01/11/2022
Q: How to remove the rear brake hose?
A:
You shall remove the tire and wheel assembly, the brake hose bracket bolt, the brake hose fitting bolt, the 2 brake hose fitting gaskets, and the brake hose.
By Bob
GM Specialist
01/11/2022
Q: What kind of tools will be required in the replacement of the brake pipe?
A:
The tools required include J 45405 Pipe Flaring Tool Kit.
By Bob
GM Specialist
01/11/2022
See more FAQs (1)
FAQ for Other Repair Info
Q: How do you install the power brake booster vacuum check valve?
A:
You can install the power brake booster check valve, connect the electrical connector, and the quick-connect fitting, and install the fuel injector sight shield.