FAQ for Pillar Panels Repair
Q: What should you snap into the liftgate lower trim finish panel when replacing the Liftgate Upper Trim Finish Panel?
A:
You should snap the left and right outboard lower ends of the trim finish panel into the liftgate lower trim finish panel.
By BobGM Specialist
02/11/2022 Q: What should you do before replacing the Center Pillar Lower Trim Panel?
A:
You should disable the SIR, and remove the rear side door opening floor carpet retainer and the body hinge pillar trim panel.
By BobGM Specialist
02/11/2022 Q: What is the recommended torque for the center pillar upper trim panel fastener?
A:
You can tighten the fastener to 2 Nm (18 lb in).
By BobGM Specialist
02/11/2022 Q: What should you do before replacing the Windshield Side Garnish Molding?
A:
You should disable the SIR system.
By BobGM Specialist
02/11/2022 Q: How many clips does the center pillar upper trim have?
A:
The center pillar upper trim has a total of 2 clips.
By BobGM Specialist
02/11/2022 Q: How many fasteners does the cargo tie-down loop have?
A:
The cargo tie-down loop has a total of 2 fasteners.
By BobGM Specialist
02/11/2022 Q: What should you do when replacing the windshield side garnish molding?
A:
You should transfer all necessary components.
By BobGM Specialist
02/11/2022 Q: What should you remove before replacing the Quarter Window Trim Finish Panel?
A:
You should remove the body side trim panel and remove the rear seat lower anchor plate bolt on the side of the trim panel being replaced.
By BobGM Specialist
02/11/2022 Q: How do you disengage the clips?
A:
You can gently pull on the garnish molding to disengage the clips.
By BobGM Specialist
02/11/2022 Q: What should you remove before replacing the Left Side Body Side Trim Panel?
A:
You should remove the rear compartment front carpet opening cover, the rear end trim finish panel and the rear side door opening floor carpet retainer.
By BobGM Specialist
02/11/2022 See more FAQs (28)