Part Description: 2010 Chevrolet Corvette Hvac Heater Molded Hose
More Info
Vehicle Fitment
2010 Chevrolet Corvette | All Trims | 8 Cyl 7.0L
2010 Chevrolet Corvette | All Trims | 8 Cyl 6.2L
$13.97
FAQ for Heater Hose Repair
Q: How many bolts hold the heater pipe assembly to the heater core?
A:
Only 1 bolt holds the heater pipe assembly to the heater core.
By Bob
GM Specialist
08/04/2022
Q: What is the heater inlet hose installation procedure?
A:
First, install the heater inlet hose on the vehicle and connect the heater inlet hose to the water pump. Connect the heater inlet hose to the underhood junction box retainer clips and the heater pipe assembly. Engage tension on the heater inlet hose clamp at the heater pipe assembly and fill the cooling system.
By Omar
GM Specialist
05/04/2022
Q: What is the torque spec on the heater pipe assembly retaining bolt?
A:
The heater pipe assembly retaining bolt should be torqued to 10 Nm (89 in/lbs.).
By Bob
GM Specialist
01/04/2022
FAQ for Other Repair Info
Q: What is the air conditioning condenser installation procedure?
A:
First, position the A/C Condenser into the vehicle and lower the A/C condenser to secure the A/C condenser tabs into the radiator slots. Next, remove the RH radiator air baffle upper retainer pin and install a new seal washer onto the front evaporator inlet line.
Q: What is the air duct air temperature sensor installation procedure?
A:
First, install the left upper Air Temperature Sensor to the air distribution duct and connect the left upper air temperature sensor electrical connector. Finally, install the IPC.
Q: What is the blower motor installation procedure?
A:
Install the Blower Motor to the HVAC module and install the blower motor retaining screws. Tighten the screws to 1.6 Nm and connect the blower motor electrical connector. Next, install the RH insulator panel.