Part Description: 2010 Chevrolet Colorado Universal Joints
More Info
Vehicle Fitment
2010 Chevrolet Colorado | Base, LS, LT, Sport, Sport LS, WT, Z71, Z71 LS, Z85, Z85 LS | 4 Cyl 2.8 L GAS, 4 Cyl 2.9 L GAS, 5 Cyl 3.5 L GAS, 5 Cyl 3.7 L GAS, 8 Cyl 5.3 L GAS
Part Description: 2010 Chevrolet Colorado Universal Joints
More Info
Vehicle Fitment
2010 Chevrolet Colorado | Base, LS, LT, Sport, Sport LS, WT, Z71, Z71 LS, Z85, Z85 LS | 4 Cyl 2.8 L GAS, 4 Cyl 2.9 L GAS, 5 Cyl 3.5 L GAS, 5 Cyl 3.7 L GAS, 8 Cyl 5.3 L GAS
$98.05MSRP: $162.29
You Save: $64.24 (40%)
FAQ for Cv Joint Repair
Q: How do you install the wheel drive shaft inner joint?
A:
You can install the retaining clamp, the retaining ring, and the seal onto the D/O joint housing, and secure the seal.
By Omar
GM Specialist
16/03/2022
Q: What is the proper way to remove the wheel drive shaft outer joint?
A:
The proper way is to remove the inner seal, and the outer seal, and cleaner the grease out of the C/V joint.
By Bob
GM Specialist
14/03/2022
Q: What is the removal procedure for the wheel drive shaft inner joint?
A:
The procedure is to remove the D/O joint housing, the cage, the inner race, and the seal.
By Bob
GM Specialist
14/03/2022
FAQ for Other Repair Info
Q: How do you install the Rear Axle Shaft Seal and/or Bearing?
A:
Use the J23690 and the J8092 to install the Axle Bearing, and then use the J21128 to install the axle shaft seal, the axle shaft, the tire and wheel assembly, next fill the rear axle with axle lubricant, lastly, lower the vehicle.
Q: What is the differential carrier assembly installation procedure?
A:
First, lift the front Differential into position and install the mounting bracket to the differential housing. Install the vent hose, and the electric motor actuator and tighten them to 22 Nm. Next install the electrical connector, the front wheel drive shafts, and the front propeller shaft.
Q: What is the rear axle shaft installation procedure?
A:
Install the rear Axle Shaft, the C-lock to the rear axle, and the pinion shaft. Next, install the lock bolt and tighten it to 25 Nm. Install the rear brake drums from the vehicle and the rear axle housing cover and gasket. After that fill the rear axle with fluid.