Part Description: 2010 Chevrolet Colorado Camshaft Position Sensor
Vehicle Fitment
2010 Chevrolet Colorado | All Trims | 4 Cyl 2.9L
2010 Chevrolet Colorado | All Trims | 5 Cyl 3.7L
FAQ for Camshaft Position Sensor Repair
Q: How do I install the Camshaft Position Sensor?
A:
Install a new O-ring seal to the CMP sensor and lightly lubricate the O-ring seal with clean engine oil. Install the CMP sensor into the cylinder head and tighten the bolt to 10 Nm (89 LB IN).
By Omar
GM Specialist
17/03/2022
Q: How do I remove the Camshaft Position Sensor?
A:
Start with disconnecting the engine wiring harness electrical connector from the camshaft position sensor. Remove the CMP sensor retaining bolt and sensor from the cylinder head. Discard the O-ring seal.
By Omar
GM Specialist
16/03/2022
Q: What should I avoid doing when servicing the Camshaft Position Actuator?
A:
Do not push or pull on the reluctor wheel of the camshaft position actuator during removal or installation. The reluctor wheel is retained to the front of the CMP actuator by 3 roll pins. Pushing or pulling on the wheel may dislodge the wheel from the front of the actuator.
By Bob
GM Specialist
14/03/2022
FAQ for Other Repair Info
Q: What is the crankshaft position sensor installation procedure?
A:
First, install a new O-ring seal on the CKP sensor and lightly lubricate the O-ring seals with clean engine oil. Install the CKP sensor into the engine block and the CPK sensor bolt. Tighten the bolt to 10 Nm and connect the engine wiring harness electrical connector to the CKP sensor.