FAQ for Brake Pad Set Repair
Q: What is the recommended bolt torque for the lower brake caliper guide pin bolt?
A:
The recommended bolt torque is 64 Nm (47 lb-ft).
By OmarGM Specialist
19/03/2022 Q: What needs to be done when reusing the brake pads?
A:
Thoroughly clean the brake caliper bracket mating surfaces and clean the brake pad shims with denatured alcohol and allow them to dry.
By OmarGM Specialist
17/03/2022 Q: What should be done if the brake fluid is higher than midway between the maximum full point and the minimum allowable level?
A:
Remove brake fluid to the midway point before proceeding.
By OmarGM Specialist
17/03/2022 Q: What should be done if the brake fluid is midway between the maximum full point and the minimum allowable level?
A:
No brake fluid needs to be removed from the reservoir before proceeding.
By BobGM Specialist
17/03/2022 Q: What should be done when the engine is off?
A:
Gradually apply the brake pedal approximately 2/3 of its travel distance.
By OmarGM Specialist
17/03/2022 Q: What should be removed if installing new disc brake pads?
A:
Remove and discard the brake pad shims.
By OmarGM Specialist
17/03/2022 Q: How do you install the disc brake pads?
A:
You can install the brake pad shims, and the inner/outer brake pads, and fill up the master cylinder reservoir.
By BobGM Specialist
16/03/2022 Q: What is the removal procedure for the disc brake pads?
A:
The procedure is to remove the tire/wheel, the lower brake caliper bolt, and the inner/outer brake pad.
By OmarGM Specialist
14/03/2022 Q: Why should you burnish your brake pads and rotor?
A:
You should burnish the brake pads to make sure the braking surface is working properly.
By OmarGM Specialist
13/03/2022 See more FAQs (4)