Part Description: 2010 Chevrolet Colorado AC Tube Valve
More Info
Vehicle Fitment
2010 Chevrolet Colorado | Base, LS, LT, Sport, Sport LS, WT, Z71, Z71 LS, Z85, Z85 LS | 4 Cyl 2.5 L GAS, 4 Cyl 2.8 L DIESEL, 4 Cyl 2.8 L GAS, 4 Cyl 2.9 L GAS, 5 Cyl 3.5 L GAS, 5 Cyl 3.7 L GAS, 6 Cyl 3.6 L GAS, 8 Cyl 5.3 L GAS
Material: Green Rubber O-Rings, Black Aluminum Gasket
Style: O-Ring & Gasket Kit
UPC: 096361268241
Part Description: 2010 Chevrolet Colorado A C System O Ring And Gasket Kit
More Info
Vehicle Fitment
2010 Chevrolet Colorado | All Trims | All Engines
$13.27
FAQ for A/C System Seal Kit Repair
Q: How do you install the A/C system seal?
A:
You can check the seal washer for any damage, and install the new seal washer, and the A/C refrigerant components.
By Bob
GM Specialist
16/03/2022
Q: How do you remove the A/C O-ring seal?
A:
You can remove the A/C refrigerant components, and the O-ring seal, and throw away the O-ring seal.
By Bob
GM Specialist
16/03/2022
Q: What is the installation procedure for the A/C O-ring seal?
A:
The procedure is to remove the cap from the A/C components and install the O-ring seal and the A/C components.
By Bob
GM Specialist
15/03/2022
Q: What is the removal procedure for the A/C system seal?
A:
The procedure is to remove the seal washer, inspect the A/C refrigerant, and throw away the sealing washer.
By Omar
GM Specialist
14/03/2022
FAQ for Other Repair Info
Q: What is the blower motor installation procedure?
A:
Install the Blower Motor and connect the blower motor electrical connector. Install the blower motor cooling tube and install the blower motor mounting screws. Tighten the screws to 2 Nm and install the right hinge pillar trim panel.
Q: What is the blower motor resistor assembly installation procedure?
A:
First, install the Blower Motor Resistor next install the blower motor resistor mounting screws. Tighten the screws to 1.9 Nm and connect the blower motor resistor electrical connector.
Q: How do you install the Heater Inlet Rear Hose?
A:
You need to install the heater inlet rear hose, reposition the heater inlet rear hose clamp, connect the heater inlet rear hose quick connect fitting, and fill the cooling system.