Notes: Before Removing The Water Pump It Is Recommended To Install GM Tool J43651 Or Equivalent To Keep The Timing Chain And Gears Properly Synchronized;See Vehicle Manufacturer Recommendation for Replacement of Timing Components;Includes Back Housing
Fan Clutch Included: No
Housing Material: Aluminum
Hub Height: 74.00 mm
Hub Hole Quantity: 3
Impeller Material: Composite
Impeller Rotation: Standard
Impeller Vane Quantity: 8
Installation Warnings: Yes
Mounting Hole Quantity: 4
Pulley Included: No
Water Pump Drive Type: Timing Chain
Part Description: 2010 Chevrolet Cobalt Engine Coolant Water Pump
Part Description: 2010 Chevrolet Cobalt Remanufactured Water Pumps
More Info
Vehicle Fitment
2010 Chevrolet Cobalt | All Trims | 4 Cyl 2.0L
2010 Chevrolet Cobalt | All Trims | 4 Cyl 2.2L
FAQ for Water Pump Repair
Q: How many bolts attach to the water pump?
A:
4 Bolts attach to the pump.
By Omar
GM Specialist
14/01/2022
Q: What is the recommended bolt torque for the rear water pump bolts?
A:
The recommended bolt torque is 25 Nm (18 LB-FT).
By Bob
GM Specialist
11/01/2022
Q: What is the recommended bolt torque for the water pump sprocket bolts?
A:
The recommended bolt torque is 25 Nm (18 LB-FT).
By Bob
GM Specialist
11/01/2022
Q: What should be done before servicing the water pump?
A:
You will need to lift and support the vehicle and remove the right-side engine splash shield.
By Bob
GM Specialist
10/01/2022
Q: What special tools will I be needing when servicing the water pump?
A:
You will be needing a water pump holding tool.
By Bob
GM Specialist
08/01/2022
FAQ for Other Repair Info
Q: What is the engine coolant thermostat housing service procedure?
A:
Tighten the Thermostat Housing bolts to 10 Nm. Drain the cooling system and remove the thermostat. Next disconnect the inlet and outlet heater hoses. Remove the turbocharger coolant return pipe and disconnect the coolant temperature sensor harness connector.
Q: How do you install the oil feed pipes?
A:
You can install the eight low, the transmission oil filter, the oil pan, gasket, and reset the TAP.
Q: How do you install the radiator surge tank inlet hose?
A:
You can install the surge tank inlet hose, and the charge air cooler inlet pipe, and fill up the cooling system.