2010 Chevrolet Cobalt | Base, LS, LT, LTZ, Sport, SS | 4 Cyl 2.0 L GAS, 4 Cyl 2.2 L GAS, 4 Cyl 2.4 L GAS
FAQ for Trunk Lid Latch Repair
Q: How do I install the Rear Compartment Lid Latch Striker?
A:
Position the lock striker to the alignment marks, install and tighten the striker bolts and slowly close the compartment lid to inspect the striker. Lastly, tighten the striker bolts to 10 Nm (89 lb in).
By Bob
GM Specialist
18/01/2022
Q: How do I remove the Rear Compartment Lid Latch Striker?
A:
You will need to mark around the striker with a grease pen to retain the position of the lock. Remove the 2 bolts attaching the striker. Now remove the striker from the vehicle.
By Bob
GM Specialist
17/01/2022
Q: How do I remove the rear compartment lid latch?
A:
Remove the latch through the access hole.
By Omar
GM Specialist
17/01/2022
Q: How many bolts attach to the rear compartment lid latch?
A:
2 Bolts attach the rear compartment lid latch.
By Bob
GM Specialist
14/01/2022
FAQ for Other Repair Info
Q: How do I remove the Rear Compartment Lid Release Switch?
A:
Start with disconnecting the electrical connector, then push the 2 tabs to release the switch.
Q: What type of tool should I use to release the clips?