Part Description: 2010 Chevrolet Aveo Front Passenger Side ABS Speed Sensor
More Info
Vehicle Fitment
2010 Chevrolet Aveo | All Trims | 4 Cyl 1.6L
FAQ for ABS Wheel Speed Sensor Repair
Q: What is the front wheel speed sensor installation procedure?
A:
Install the front wheel speed sensor to the steering knuckle and tighten it to 8 Nm. Next, install the wheel and lower the vehicle.
By Omar
GM Specialist
21/01/2022
Q: What is the rear wheel speed sensor installation procedure?
A:
Install the rear wheel speed sensor to the backing plate and tighten the rear wheel speed sensor bolt to 8 Nm. Finally, connect the rear wheel speed sensor electrical connector and the negative battery cable.
By Bob
GM Specialist
20/01/2022
Q: What is the rear wheel speed sensor removal procedure?
A:
Disconnect the negative battery cable and the rear wheel speed sensor electrical connector. Next, remove the rear wheel speed sensor bolt and the rear wheel speed sensor from the backing plate.
By Omar
GM Specialist
20/01/2022
FAQ for Other Repair Info
Q: How do you remove the brake drums?
A:
You will need to remove the rear tire/wheel assembly, and the Brake Drum screws, and pull the drum off the hub.
Q: What is the front brake hose installation procedure?
A:
First, install the new Brake Hose to the caliper and tighten the front brake hose-to-caliper bolt to 40 Nm. Next, install the brake hose and the E-ring retainer to the wheel housing bracket. Connect the brake line to the brake hose and tighten the brake line to 16 Nm.
Q: What is the parking brake cable installation procedure?
A:
First, install the new Parking Brake Cable through the brake backing plate and the brake shoes/drums. Next insert the plastic sleeve into the brake backing plate and press in the retaining ring. After that install the parking brake cable to the underbody side brackets on each side of the vehicle and tighten the bolts to 12 Nm. Install the parking cable on the rear axle brackets on each side of the vehicle and tighten the bolt to 12 Nm.