FAQ for Universal Joints Repair
Q: What should be replaced if the slip yoke is damaged?
A:
Replace the slip yoke and use a new universal joint. Do not re-use the old universal joint.
By BobGM Specialist
02/11/2022 Q: What special tools will I be needing when servicing the Universal Joint Nylon Injected Ring?
A:
You will need a U Joint Bearing Separator and a U Joint Bearing Spacer Remover.
By BobGM Specialist
02/11/2022 Q: What special tools will I be needing when servicing the Universal Joint External Snap Ring?
A:
You will need a U Joint Bearing Separator and a U Joint Bearing Spacer Remover.
By BobGM Specialist
02/11/2022 Q: After removing the spider from the yoke slip what should be done?
A:
You will need to clean the propeller shaft yoke and slip the yoke of any contaminants that could prevent the retaining rings or the bearing cups from being properly installed.
By BobGM Specialist
02/11/2022 Q: What if there seems to be a hang-up or binding?
A:
Stop pressing, and inspect the needle bearings for misalignment in the bearing cup.
By BobGM Specialist
02/11/2022 Q: What should be done if seating the retainer become difficult?
A:
Spring the yoke slightly with a firm blow from a dead blow hammer.
By BobGM Specialist
02/11/2022 See more FAQs (1)