Notes: Grade: Aftermarket; Description: Seal included; Thread Size: M12 X 1,5; Plug (Connector): 2 Pins
Colour: Black
Height [mm]: 19
Length [mm]: 19
Number of Poles: 2
Packaging Depth [cm]: 3
Packaging height [cm]: 3,3
Packaging width [cm]: 5,8
Spanner Size: 19
Supplementary Article/Supplementary Info: with seal
Thread Size: M12x1,5
Weight [kg]: 0,02962
Width [mm]: 59
Part Description: 2010 Chevrolet Avalanche Engine Coolant Temperature Sensor
More Info
Vehicle Fitment
2010 Chevrolet Avalanche | All Trims | 8 Cyl 5.3L
FAQ for Coolant Temperature Sensors Repair
Q: How do I remove the Engine Coolant Temperature Sensor?
A:
Start with draining the cooling system to a level below the sensor. Next, disconnect the electrical connector from the sensor, and remove the sensor from the vehicle.
By Bob
GM Specialist
01/11/2022
Q: How do I install the Engine Coolant Temperature Sensor?
A:
If reusing the same sensor use thread lock. Next, install the sensor and tighten it to 20 Nm (15 lb. ft.). Next, connect the electrical connector to the sensor. Refill the cooling reservoir.
By Bob
GM Specialist
01/11/2022
FAQ for Other Repair Info
Q: What is the radiator grille reinforcement support service procedure?
A:
Remove the hood latch cable from the Radiator grille reinforcement support and tighten the radiator reinforcement support screws to 9 Nm.
Q: Where will I need to remove the radiator inlet and outlet hose from?
A:
Remove the radiator inlet hose from the Water Pump.
Q: What is the proper way to install the engine coolant thermostat?
A:
The proper way is to install the Thermostat and the thermostat housing.