FAQ for Cigarette Lighters Repair
Q: How do you remove the cigar lighter receptacle?
A:
You can remove the auxiliary power outlet fuse, the receptacle, and the plastic latches.
By BobGM Specialist
29/10/2022 Q: What is the cigar receptacle or 12-volt accessory power installation procedure?
A:
First, route the connector through the retainer and align the accessory power receptacle retainer to the slot in the opening. Next, install the retainer and connect the electrical connector to the receptacle. Align the tabs on the receptacle to the slots in the retainer and install the accessory power receptacle fuse.
By BobGM Specialist
29/10/2022 Q: What is the installation procedure for the cigar lighter receptacle?
A:
The procedure is to install the retainer and connect the electrical connector, and the power receptacle fuse.
By BobGM Specialist
29/10/2022 Q: What is the testing short-to-ground procedure?
A:
Remove the power feed from the suspect circuit and disconnect the load. Next, set the rotary dial of the DMM to the ohm position and connect one lead of the DMM to one end of the circuit to be seated. Finally, connect the other lead of the DMM to a good ground.
By BobGM Specialist
29/10/2022 Q: What is the tool number for the cigar lighter socket remover?
A:
The tool number is J42059 for the special tool.
By BobGM Specialist
29/10/2022 Q: How many nuts does the tire inflator bracket have?
A:
The tire inflator bracket has a total of 3 nuts.
By BobGM Specialist
29/10/2022 See more FAQs (1)